Burning Excess Search Results

How To: Replace the glass digitizer touch screen on an iPhone

This is a tutorial on how to replace the screen on your ipod touch. This video is specific to the third generation ipod touch. You can tell if your ipod is a third generation because it only has two lines of writing on the back bottom. To begin use a safe open pry tool to open the ipod touch. Run the tool between the metal chrome frame and the glass digitizer. There are many clips on all sides and they all need to be released. Begin prying at the bottom and then work your way to the sides. Wh...

How To: Cut a cigar the best way

Many people ruin a good cigar by a badly placed cut. YouTube user Cigaraficionadovideo is here to help. First in order to understand the cutting mistakes you must first know how a cigar is put together. A hand made cigar is held together a the tip by, what is called, a cap. When cutting this cap you want to do it above the shoulder. Be carful here because a bad cut a little lower could result in the wrapper falling it apart can lead to a mouth full of tobacco which will pretty much ruin your ...

How To: Make farmer's cheese with Chef Janie

In order to make Farmer’s Cheese at home, you will need the following: a Dutch oven, a plastic or wooden spoon, 2 pints of whole milk, a colander, cheese cloth, 1 cup of buttermilk, butcher’s string, spatula, 2 tsp of lemon or juice or vinegar, and ¾ tsp of salt.

How To: Create a frilled layers out of gumpaste for cakes

This video is showing how to create frilled layers on a cake. First you need one mini cake, rolling pin, one knife, one cocktail stick, rolling board, icing sugar, glue or water, and gumpaste to do this. First you have to roll out the gumpaste to very thin layer. Next cut it out round with the frill cutter. Next take a cocktail stick and then create wavy effect to the gumpaste. Sprinkle some icing sugar on the board to use it fast. Next cut the gumpaste. Next take the mini cake and apply some...

How To: Make a junk journal out of random items

To make a journal made of junk you're going to need a couple of things. First an unbleached linen thread because it doesn't bleed out into your work, you'll need a candle, a binder clip and a stack of papers. The papers you need to fold down the middle and put in four evenly spaced holes down its spine so that it looks like a book. Use the clip to hold the papers together while you measure the thread. The thread needs to be three times the height of your book. Wax this thread using the candle...

How To: Make rustic themed gift basket

This video shows you how to make a rustic gift basket. For this project, you will need the following: an oval metal pail, crinkle paper, chocolate bars, cutting board, cookies, dried fruit, crackers, almonds, smoked salmon, cheese, caramel corn, grapes, a standard cello bag, sharp scissors, ribbon, and a knife.

How To: Deal with a flooded Nitro engine on an RC vehicle

Alishan Mao describes how to fix a flooded Nitro Engine on an RC car, remove the excess fuel, and start the engine. Flooding of the engine can occur when priming the engine. If you prime the engine too much, the engine can get flooded, making it difficult to pull the pull start. A simple way to fix this is to remove the glow plug. Cover the top of the engine with cloth or rag and hold it there so that the fuel does not splash all over the place. Pull the pull start several times. The fuel wil...

How To: Make a tiara-esque headband

Tiara-esque headbands are fun to make, and more importantly, fun to wear! You will need, 1 basic wide headband, 1 yard of cotton fabric, 1 yard tulle, flowers from the Crafts section, scissors, beads and rhinestones for details, a glue gun. Lay the headband over the fabric, towards the edge. Mold the fabric around the headband, leaving some extra fabric at the ends. Cut the fabric. Glue the fabric from the underside of the headband, and glue from end to end. Cut all excess fabric away, and tr...

How To: Make a simple daisy necklace

To make a daisy chain beaded necklace you must get three different bead colors, two that are size eleven and one that is size four. The size eleven beads are for the stems and the outer part of the flower, while the size four beads are for the inside of the flowers. You will also need nylon thread and a clasp, such as a magnetic clasp. First slide the clasp on first and connect it to the thread. Next follow the following pattern for the beads, 8 for the stem (size 11), 6 for the outer petals ...

How To: Build a retaining wall for your home

To create a retaining wall all you need to do is follow these simple steps. To begin you will need to get many interlocking wall blocks and either sand or concrete. The first step is to plot and measure the retaining wall's size and shape. Use your measurements to figure out the amount of retaining wall blocks that you will need. The second step is to mark off the spots in your yard that you would like the retaining wall to be. Then dig your trenches in these spots to level out the land and t...

How To: Make a Santa hat bead from polymer clay

To make a Santa hat bead, begin with red clay and condition it by kneading it with your fingertips. Form the clay into a thick worm shape, with it being the thickest at one end then tapering off. Use your fingertip to make a shallow indentation on the thicker end, and remove any excess clay from the thinner end (total length should only be an inch or two). Curve the thin end over slightly to create a hook shape at the top of the hat. Take a small ball of white clay and make a small hole in it...

How To: Make raw "fried" mushrooms

Karen Knowler demonstrates how to make a quick and easy recipe called Fried Mushrooms in this video. This dish can be eaten as it is or topped with your salads. She takes in a generous quantity of mushrooms and slices them (obviously after they are washed!). Then olive oil is drizzled over the mushrooms and they are mixed well. Next, the juice of a whole fresh lemon is poured over the mushrooms with olive oil, to give an added taste. Next, she crushes two whole garlic pods and adds them in. T...

How To: Perfectly bind a book with two different methods

Demonstrator Andy Hirsch offers a tutorial on how to perfectly bind a book using two different methods. The first method is with binding clips the second with a binding jig. You will need and cutting mat, X-acto knife, paint brush, ruler, binder clips and binding glue. Use use 8 1/2" X 11" paper folded in half for the book pages and 11"x 17" page for the cover. In the 'Binder Clip Method', you make all the pages and cover flush and use the binder clips to keep everything together. Ad glue to ...

How To: Make Filipino-style orange chicken

In this video, from panlasangpinoy we learn how to make a Filipino style orange chicken. First the ingredients are shown as: boneless chicken breast, brown sugar, soy sauce, garlic, corn starch, green onion, vinegar, flour, egg, salt, orange juice, and ground black pepper. In a container, he adds the flour, salt, black pepper. Cover the container and shake it up. Open it back up, dip chicken to egg and put chicken in container. Close the container and shake it up again. Next it's time to deep...

How To: Change a string on your guzheng

This video explains how to change a string of guzheng. The process is well described in the video with each and every steps clearly. The thing that is to be done is loosen the peg in a an anticlockwise direction using a tuning tool to remove the string. Thus remove it. If there is no string to begin with then loosen the tuning first before fitting a new string. Than take a new string and insert the pointed end through the hole from the back of the guzheng. To get it on other side pull it thro...

How To: Solder a wire

This video describes how to solder a wire. The first thing you have to remember is that the wires should be cleaned, shiny, and bright. Then trim about 1/2-inch of the insulation of the wires and then make a secure mechanical connection. Next, put some soldering pencil clean and shiny 60/40 rosin core solder. Do not use 50/50 core solder. Start by making sure that the soldering iron is tint. Put the soldering iron underneath the joint. Heat tends to rise and then touch the solder to the joint...

How To: Strip old paint and varnish

The hardest part of stripping off old paint and varnish is getting all of the residual residue out of the details such as the panels and the raised or indented parts of the piece you are working on. You can make the job a lot easier by using the right tools. Use a small bristle brass brush to get into crevices and cracks. Brass is good because the brass bristles are softer and won't scratch the piece you are working on. Next take a piece of dowel and sharpen it in a pencil sharpener. The shar...

How To: Fill and touch-up a gouge on a table edge

To fill a gouge on a table edge you start by using auto body filler. Auto body filler is a two part substance. The catalyst is red and the resin is grey. When they are properly mixed it will be a uniform pink color. To keep the substance from spilling out of the damaged area put a piece of tape on the side of the table. Take some filler and force it down into the cavity formed by the tape along the side of the table. Let it dry for 3-4 minutes. Take the tape off and use a knife to trim off th...

How To: Remove and replace a toilet

Changing a toilet is really not the dirty and difficult job that you would imagine. Start by turning the water off using the valve that is located on the wall. Empty the tank by flushing the toilet and holding up the drain valve. Soak up the excess water with a sponge. Disconnect the water line and loosen the bolts that hold the toilet down. Cut through the caulk seal at the bottom of the toilet. Remove the toilet and the wax ring that is around the opening of the drain. Remove the wax ring a...

How To: Tile large & natural stone tiles

To tile with large format and natural stone tiles onto walls you must first make sure the walls are flat, clean, dry, and free of any dust, dirt, oil, grease, and any other loose material. Ensure that surfaces are suitable and prepared as advised. Then use the Dunlop Universal Bonding Agent where you will be applying the tile. For gypsum plaster and gypsum plasterboard, apply two coats of Dunlop Universal Bonding Agent, diluted with one part bonding agent, two parts water. Then allow primer t...

How To: Sear halibut with tomato, fennel, cucumber and mint

Secret Ingredient host Mark Law and Denver chef Jean Philippe Failyau of Osteria Marco take the mint out of the mojito and add it to a fresh summertime salad of cherry tomatoes, fennel, red onion, cucumber and mint, served over seared halibut. Follow along in this cooking how-to video as Whole Food's Market shows you how to prepare this delicious seafood dish. The tomato, fennel, cucumber and mint add a refreshing taste to the seared halibut.

How To: Build a water trap to stop zombies and other creatures in Minecraft

Sometimes taking the route where you don't fight at all in Minecraft is the best plan of attack! If you're looking for a clever way to take down almost all types of creatures (well, except for spiders), check out this awesome video! You'll learn how to make a crafty water trap that'll keep them stuck until they drown to death, or burn up in the sun, and then it's a quick, simple matter of running down there and getting the loot that they drop.

How To: Download and play free PSP games

In this tutorial, we learn how to download and play free PSP games. First, go to the website ManyISO. After you go onto the site, you can search for the games that you want to play. Download the game, then have it download through the software that you choose. Once it's finished downloading, install it to your computer. After this, you will be able to open it up on your computer and burn it onto a disc that you can use on your game console. Download as many games as you'd like, then enjoy pla...

How To: Copy any DVD in 20 minutes with DVD Decrypter

In this video tutorial, viewers learn how to copy any DVD in 20 minutes. Users will need to begin by downloading and installing the program, DVD Decrypter from the link provided in the video description. Once downloaded and installed open the program and load the DVD into the DVD drive. All the files of the DVD will be displayed in the window on the right of the program. Make sure that your computer has enough free space. Then click on the burn image to begin copying the DVD This video will b...

How To: Remove paper from between a bottle & coin seamlessly

Check out this cool trick. In this video, Mr. G teaches you how to win a bar bet with this funky science-based trick. Place a piece of paper in between a glass wine bottle and a coin and bet someone that you can remove the paper without disturbing the coin or bottle at all. The secret is tricky and involves basically burning the paper away until you can snap it right off. So, follow along and win yourself a ton of free drinks next time you're out!

How To: Bake homemade brownies

In this video, the recipe for Brownies has been demonstrated. This is useful for those who love to eat homemade food. To make the brownies, you have to take 2 cups of white sugar and 1 cup of flour. Add 4 eggs and some vanilla essence. Mix all the ingredients. In another pan take some butter and melt it with chocolate. Keep stirring so that the chocolate does not burn. Add the chocolate and butter mixture to the sugar, flour and eggs. Blend properly. Then add some chopped nuts. Put the mixtur...