Draining Holes Search Results

How To: Build a linear slide bearing for a CNC router

A CNC router machine is probably the most useful tool a hobbyist can own, but the price for a CNC machine on the market is way more than the average hobbyist is willing to spend. You can build your own CNC with very basic tools, little knowledge of machinery, mechanics, or electronics, but be warned, these machines are inherently dangerous, so wear the proper protection and use common sense. At the very least, read the instructions and precautions on every tool you use.

How To: Install a sink properly

Tim Carter shows you how to install the sink with these easy to follow tips. Watch this video for best results. Position the new sink upside down on the countertop and accurately trace the outline of the sink. This provides a guideline for the real mark for the cut-out. The cutout will normally be about 3/16" inside the original mark. This allows for the lip of the sink to overhang the counter top. Check the sink installation directions for the proper measurement. Don't make square corners wh...

How To: Field dress a deer

In this tutorial we learn how to field dress a deer. First, put some gloves on and grab a sharp knife. After this, puncture a hole in the lower half of the throat of the deer. Next, start to cut up until you reach the neck. There will be a lot of blood that comes out, just a warning. Then, you will see the inside of the deer start to come out from the fur. Cut the piece of the neck and then tie together at the end. To finish, go to the rear end of the deer and cut from the hole. Tie it with a...

How To: Make a bow and arrow from a ball point pen

In this tutorial, we learn how to make a bow and arrow from a ball point pen. First, you will take the top and bottom off of the pen. Then, use a knife to poke a hole in one side of the case until you reach the other side. Now, make small notches in the top of it so you can stick a rubber band on it. Do this on both sides and try to make it equal. Now, take the top of the pen and stick it in the little hole you made in the middle. Then, take the rubber band and stick it on. Then, shoot this a...

How To: Tie a Knute hitch

In this video, we learn how to tie a Knute hitch. The purpose for this is to make an easy dummy cord on something with a hold for it. To start, tie a simple overhand knot in one end and then make a bite in the knot. With this bite, insert this into the hole in your item. Once it's through, take the end with the knot and put it through the loop. Then, pull the end of the string until it's tight over the item with the hole. Then you can use this as a handle so you don't lose your item!

How To: Make a wooden soda holder that seems to defy gravity

In this video, we learn how to make a wooden soda holder that defies gravity. First, cut a hole into a piece of wood that is large enough to fit the cap of a 2 liter bottle of soda. Now, with the bottle still full, place the bottle into the hole and raise the piece of wood up so it's sitting on the edge of a table. Now, the wood should stay there without you having to hold it. This will look like it's defying gravity, but it is just the soda and wood being positioned perfectly so it doesn't f...

How To: Make a cigar box clock

This video tutorial is in the Home & Garden category which will show you how to make a cigar box clock. The parts used for this project are a cigar box, quartz clock movement and hands for the clock. The tools needed are a drill bit and pliers or a wrench. Take your cigar box drill a hole in the center with a drill bit and put the time markers on it as shown in the video. The size of the hole will depend on the shaft diameter of the clock movement. Now fix the clock movement from inside the b...

How To: Fill out a scorecard for a golf game

If you are playing a serious game of golf you will need to keep score. This tutorial will show you how to fill the score card out if you are a beginner. Filling out a scorecard in golf involves counting one point for every stroke taken at each hole, and the first nine holes are scored on the front of the card while the second nine are scored on the back of the card. Fill out a golf scorecard accurately, taking handicaps into consideration and make sure you have the best possible game, with he...

How To: Mount a fish finder on your kayak

In this Outdoor Recreation video tutorial you will learn how to mount a fish finder on your kayak. There are many ways of doing this. All the methods work. It’s just a matter of personal choice where you want to mount it. Some boats are designed for a through hole transducer and have a space for it to mount it in a hole. Take a piece of foam, trace out the transducer and cut out the foam. Now open the front hatch of the boat and glue down the foam on the flat surface of the boat. Once that ...

How To: Make homemade 3D glasses

In this tutorial, we learn how to make 3D glasses at home. First, take cardboard and cut two square holes in it. Then, take clear packing take and tape it over the holes. Once you've done this color the front of the tape with a red marker on one of the sides. On the other side, take a blue marker and color it in. That's all you need to do to watch 3D movies and television shows in the comfort of your own home. These are extremely inexpensive and can be made within just a couple of minutes. It...

How To: Repot a plant into a larger container

This video from Lowe's shows you how to successfully repot a plant into a larger container. You will know it is time to repot your plant when the roots are visible on the surface, or when they start growing through the drainage hole. If you need to repot one of your plants into a larger container, simply follow these steps: You will need a clean pot that is no more than two sizes larger than the old one. Place a wire mesh or pieces of broken clay pot over the drainage hole. Add a layer of pot...

How To: Install exterior shutters

Tim Carter shares some pointers about exterior shutters and which type of window shutters you should buy. Wood shutters are nice, but they don’t always hold up over time if not properly maintained. Vinyl window shutters are a great alternative. They are maintenance free and come in a variety of styles and colors for any style of house. Vinyl shutters come with a special fastener for quick and easy installation. Drill a 1/4" hole into the shutter and in the house, then drive the fastener into ...

How To: Make a latex facial prosthetic for Halloween

If you want to create the type of makeup look where the makeup IS the costume for Halloween, then look no further than this video. You'll be guided step by step through creating a facial prosthetic from latex. This prosthetic can be shaped any way you want to form rotting flesh for a zombie costume, scars and wounds, even bullet holes.

How To: Build a basic starting home in Minecraft

When starting out in Minecraft, the first thing you focus on is creating a shelter to seal yourself into to make it through the first night without getting eaten by a zombie or shot to death by a skeleton. But if you want something a little more conventional, try building a house to start in instead of a hole in a hillside! In this video you will get a quick walkthrough of building the house with a working door and a roof.

How To: Make a pair of distressed jeans

For just a fraction of the cost of a pair of expensive designer distressed jeans, you can make your ripped pants own at home! With just a few household items and a bit of time, you can get that worn appearance by adding a few holes and using bleach to get the right faded look.

How To: Make Punjabi mustard greens

Anuja and Hetal from Show me the Curry demonstrate how to make Sarson ka Saag, a typical Punjabi recipe made with mustard greens. Chop the mustard greens and some spinach leaves and put them in a large pot of water. Boil them for about 15 minutes, then drain and let them cool.

How To: Make asparagus carbonara with Steve Ricci

Executive Chef Steve Ricci from Prime restaurant shows you how to create a very quick Asparagus Carbonara in this video. This dish is not only filling but can be done in under twenty minutes. This homemade sauce is created in the time it takes to merely boil your pasta. The flavor of smoked bacon, parmesan, tender asparagus and pappardelle pasta combine to create a pasta dish. Drop the pasta, the pappardelle in boiling water and it will cook while you finish the sauce. Fry the bacon in a sauc...

How To: Cook crispy rice noodles

In this video tutorial, viewers learn how to make crispy rice noodles. Begin with a 6-8 oz package of vermicelli rice noodles and soak them in water for 20 minutes. Then drain the noodles into a colander and let the dry. Now add 2-3 cups of peanut oil into a wok and heat it on high temperature. Then add in a handful of the rice noodles and let it cook for 3-5 minutes. Now remove the crispy noodles and place them on a paper towel to remove some of the oil. This video will benefit those viewers...

How To: Make quick and easy tuna meatballs

On Tastyfood TV the recipe is "Tuna Meatballs". They will take you through the process of creating this recipe. It uses two small tins of tuna, two small boiled potatoes, parmesan cheese, eggs, and some breadcrumbs. The tinned tuna is drained and put in a bowl. The boiled potato is peeled and mashed in a bowl, then the tuna is added, then finally the two eggs. A pinch of salt, a sprinkling parmesan cheese, and it is all mixed together, formed into balls, and dusted with breadcrumbs. After bei...

How To: Choose colorful flowers & shrubs for the garden

This video makes suggestions in how to choose colorful flowers and shrubs in your garden. Bowle’s Mauve is a purple flowering plant that will grow and bloom until fall. It will become bushy. Another colorful choice is the Rock Rose, a pinkish flower. The Blue Salvia has blue flowers. A Bank’s Rose, only bloom for a short time. It has yellow or white flowers. Aphids tend to attack it, but it is hearty.

How To: Wash your windows with a mop and squeegee like a pro

This video shows how to wash your windows with a mop and squeegee like a pro.This process includes the following steps,Step 1Take a bucket and a mop.Step 2Fill water in the bucket and put the mop in the bucket to wet it.Step 3Take some liquid soap and apply it on the mop and then clean the windows with this mop.Step 4Now rinse the mop in the bucket and squeeze it well so that the soap is drained out of it.Step 5Now clean the windows with this mop, rinse the mop in water again and squeeze it.S...

How To: Cook steel cut oats very quickly

First of all you need Steel-Cut Oats, some water and a Tupperware box. Take the oats and then soak them in water. Add sufficient water so that the oats are completely soaked in water. There is no need to refrigerate the oats. You can leave them in your kitchen. Put a lid or covering on the top. If you wish you can also use a bowl instead of a Tupperware box. Now you have to leave the oats overnight so that they become soft and tender. In the morning you can drain out the water and use the oat...

How To: Care for house plants growing in water

Growing plants in the Southwest is different then other climates. We learn how to grow plants in water. Salt is a factor that we need to be cautious of. Salt is in soil and in water. Water, once absorbed leaves a layer of salt. It can be avoided by watering in a certain way. Changing the water frequently, a dish underneath a potted plant to drain the water and flushing out the salt and re-potting periodically. Sometimes extremes measures must be taken to hydrate a plant. In this case putting ...

How to Make Indian food: Chana daal

Sfehmi teaches you how to make a vegetarian Indian dish called chana daal. You will need yellow spit peas, a few small tomatoes, a tablespoon of salt, 3 chili peppers, half a tablespoon turmeric powder, a small pinch of onion seeds, one red spoon of red chili, and opo squash cut into smaller pieces. Put 3 tablespoons of canola oil in and add the onion seeds. Add all the spices and a tablespoon of ginger. You will also pour some water and then add the tomatoes as well. You can then add the yel...

How To: Make easy Pakistani chicken curry

This video shows you how to make chicken curry. You will need half a chicken, 1 tbsp ginger, garlic paste, 1 onion, 1/4 tsp of zeera, Cardamom pods, Assorted garam masala pieces, 1/2 tsp Red Chili Powder, 1/4 tsp Haldi/ Turmeric Powder, 1/2 tsp Coriander Powder, 1/2 tsp Garam Masala Powder, Salt to taste, 2 tbsp yogurt, 1 tomato microwaved for one minute, and Oil. Put oil in pan and add seera and onions and let it brown while stirring. Drain the oil and put the onions on a plate. Blend the yo...

How To: Make vegan whipped cream

To make a vegan whipped cream you will need 2 cans of coconut milk (whole fat ones), some powdered sugar and a mixer. First of all, the coconut milk needs to be refrigerated over night to separate the liquid part from the fat. Then you will drain the liquid. After this you will take the fat and whip it with the mixer, remember to cool down the mixing bowl and to whip it for a short time. We don't want it to warm up. Finally, you add the powdered sugar, whip it a little longer and voila! Your ...