Draining Holes Search Results

How To: Change the oil in your motorcycle

In this tutorial, we learn how to change the oil in your motorcycle. You will need: a drain pan, funnel, oil, screwdriver, filter, and paper towels. First, grab your oil pan and find your drain plug. Then, remove the plug and let the oil drain. After this has drained out, replace the plug to the motorcycle. Then, find the filter and let it drain out. Add in oil to the filter, then replace back into the motorcycle. From here, fill the motorcycle with oil, then measure it to make sure you have ...

How To: Clean a sink drain

A clogged drain is not only an unpleasant but seems to happen at the most inconvenient time. Good thing there is a simple way to unclog most minor stoppages with a few household products. Be your own plumber and keep those drains free and flowing.

How To: Create a hole in a 3D table using 3DS Max and Boujou

Creating movie-quality 3D images takes more than just 3DS Max. It takes a village of graphics programs to really make it look professional. This nine-part video tutorial will teach you how to create a hole in a coffee table using a combination of 3DS Max, After Effects, and the matchmoving software Boujou. This is high-level stuff, but the instructions are great and this video should have you compositing 3D images in no time!

How To: Repair a small hole in the wall by patching it

In this video tutorial, viewers learn how to repair a small hole in the wall. The materials needed for this process are drywall tape, water, patching compound, and a drywall knife. Begin by placing the drywall tape over the hole. Then mix some water with the patching compound and apply it over the hole. Use the drywall knife to spread the compound over the hole. Start from the middle and spread out. Finish by letting the compound dry and sand it using some sand paper. This video will benefit ...

How To: Unclog a sink drain yourself

First of all put a bucket under the trap. Now use your hand to loosen the handle of the PVC type trap. Loosen both the two plastic nuts on the ends. Remove the nuts that are holding to the drain pipe. Now when you remove this trap from the drain pipe a little dirty water comes out of it which gets collected in the bucket. Now check the trap for some hair and other clogs. This you have to remove and clean it out completely. Also check the drain pipe outlet for removing any hair or other clog. ...

How To: Play in the high register of a harmonica

Wondering how to hit high notes on your harp? In this harmonica tutorial, you'll learn how to play using the upper register. While this tutorial is geared towards intermediate players, beginners are certain to walk away with something. For more, and to get started playing in the high register of your own harmonica, just press play!

How To: Play the notes B, A, and G on a recorder with Mrs.Hill

How to play the notes b, a, and g on a recorderHillary Hill demonstrates to us how to play a mouth piece. Note b is played by completely covering the thumb hole in the back and the thumb hole in the front. Remember to cover the hole completely to avoid squicky sounds. Note a is played by covering the thumb hole in the back, the first hole at the top and the second hole. To play g, its the thumb hole and the top three holes on the piece. Its important to use the left hand because when we learn...

How To: Hide screw holes with wood plugs

There are a number of ways to deal with screw holes that are visible. You can buy some wood buttons and put them in the holes. You put a little wood glue in the hole and then tap the wood buttons into the holes using a hammer. This is a decorative solution to cover up screw holes. If you want to completely cover up the holes completely put a plug cutter on your drill and cut a plug out of a piece of wood that matches the wood that the hole is in. Take the plug put a little glue on it and tap ...

How To: Flush the coolant in a Kawasaki KLR650

This motorcycle maintenance video shows you how to flush the coolant in a Kawasaki KLR650 bike. The coolant drain is a vertical bolt (8 mm) on the front right side of the engine (the water pump). There is a horizontal bolt near it which helps hold the water pump to the engine. That one won't drain it the way you want it drained... unless you want a mess. Now that you know where to look, check out the video and see how to flush the coolant in a KLR 650.

How To: Change your car's oil to minimize wear and tear

In this tutorial, we learn how to change your car's oil to minimize wear and tear. First, you will need to gather all the equipment you need to change your oil. This will include: jacks for the car, new oil, oil pan, and filter. To start, you will need to jack your car up on the jacks until it's secure and you can reach underneath it. Now, you will unplug that drain for the oil tank and let it drain out into the oil pan. When this is finished draining (15-20 minutes), you will need to replace...

How To: Change your differential oil on a Jeep Grand Cherokee

In this tutorial, we learn how to change your differential oil on a Jeep Grand Cherokee. First, you will need to remove the drain plug from the underneath of the vehicle, then let it drain out onto an oil pan, use a pipe and pump to do this. Once it's finished draining, you will need to replace the plug. After this, grab a new pump and pour your new oil into the pump. Remove the plug again, then pump the oil back into the engine. Once the oil is full, you can replace the drain plug and check ...

How To: Change the oil in your 2002-07 Jeep Liberty 3.7L

In this tutorial, we learn how to change the oil in your 2002-07 Jeep Liberty 3.7L. First, go underneath your Jeep and remove the oil plug from the tank. Once you do this, let the oil drain out into an oil pan or plastic container. While this is draining, go to the hood of your car and find where the oil filter is. Once you find this, take out the old one and replace it with the new filter. When the oil is done draining, place the drain plug back on and then fill in the new oil to your Jeep i...

How To: Change your engine oil for maximum auto performance

In this tutorial, we learn how to change your engine oil for maximum auto performance. First, you will need to find your drain plug underneath your car and let the oil drain out of the tank until it doesn't run any longer. You may need to jack your vehicle up to do this. Once it's done draining, replace the drain plug to the oil tank. Use a new washer and bolt if you need to. Now, pop the hood on your vehicle and find the oil tank. Remove the cap and place a funnel inside of it. Pour your new...

How To: Fix a plugged up air conditioner drain hose on a Jeep Liberty

A common problem on Jeep Liberty SUVs involves the passenger side carpet getting wet because of the air conditioner drain hose being plugged, where the condensation water is supposed to drain from. The drain hose sticks out about an inch inside the engine compartment, and is relatively easy to access. All you need to do is use a wire, at least six inches, to probe into it and release and buildup. You can also blow air into the hose. Watch and learn this simple A/C repair trick.

How To: Unclog your shower drain

In this video from prohandymanlv we learn how to unclog a shower drain. Often people with long hair will have this problem as it falls out and combines with oils and shampoos to form a ball of blockage in the drain. Use gloves when working with drains. First remove the shower strainer. If you don't have the tools to grab the clog, use long screwdrivers. If it's deeper, a zippet will work. Stick it down the drain and it will grab the clog. He actually can see the clog when he unclogs this drai...

How To: Hold a recorder properly with Mrs. Hill

In this Music & Instruments video tutorial you are going to learn how to hold a recorder properly with Mrs. Hill. The bottom part of the recorder has one thumb hole at the back and seven holes on the front side. The thumb of the left hand goes on the thumb hole and the top three fingers of the left hand go on the top three holes on front side of the recorder. The other four holes are covered by the four fingers of the right hand and the right thumb goes behind the recorder. The fingers should...

How To: Make "day pickles"

Rldel149 from YouTube teaches his viewers how to make the perfect day pickles. Pick 1 gallon of small cucumbers no great than 2 inches in length. Day 1: Wash and scrub the cucumbers clean with a vegetable brush. Pour boiling water over the cucumbers once in the morning, and once in the night. Day 2: Repeat the same process as in day 1, but add in a 1/2 cup of salt. Day 3 Morning: In the morning, drain and prick the little cucumbers with a small prong fork. Make a syrup combining the following...

How To: Change the engine and oil filter on a Mercedes car

In this tutorial, we learn how to change the engine and oil filter on a Mercedes car. First, find the oil drain plug underneath the car. Remove this, then let it drain into a pan until it's finished leaking out. From here, you will place the drain plug back on, then fill up the vehicle with the correct type of oil from the hood of the car. Then, find where the oil filter is and remove it from the car. Place in the new filter, then tighten all bolts you removed. Check the level in the car to m...

How To: Change the engine oil in a Chevy truck

In this tutorial, we learn how to change the engine oil in a Chevy truck. To start, you will want to place your car up on a secure jack so you can get underneath it with ease. Next, find the oil can and drain plug underneath the truck and use a wrench to remove the bolts around them. Now, place an oil pan underneath the drain plug and let the oil leak out into this until there is no more left. Next, clean off the bolt that is used for the drain plug and remove the filter from the underneath o...

How To: Unclog a drain without toxic chemicals

Don't call a pricey plumber! Anyone with a few tools can unclog a drain -- without even resorting to those strong, toxic chemicals. Most of the time, anyway. You will need baking soda, vinegar, rubber gloves, cleaning rags or duct tape, a rubber plunger, a plumber's snake, petroleum jelly, a bucket or pan, and a length of hose. WARNING: Do not try this if you have already used a commercial drain opener, as it can create harmful fumes.

How To: Use a post hole digger as a measuring stick

Here is a simple technical to measure hole you dug with a post hole digger. Take measuring tape. Place it with the post hole digger from bottom to the end of the post hole digger. Mark each foot division on the post hole digger with a marker. So now you can measure depth of the hole you dug with post hole digger without the need of a measuring tape. If you want to dig 2 feet deep down the earth and you could not find a measuring tape to measure, but markings on the digger will help you to mea...

How To: Winterize your boat and prepare it for Winter

In this tutorial, we learn how to winterize your boat and prepare it for winter. First, you will remove the drain plug from the boat and let the water out. After this, remove the oil drain and drain the oil out of the motor while it's warm. Exhaust fumes while the engine is turned on as well. Now, start the engine and let it run for a few minutes staying idle. After doing these steps, your boat will be ready to be stored for the winter. So when you turn it on when it's ready, it won't stall o...

How To: Change your own oil on a 2006 Ford Explorer

In this tutorial, we learn how to change your own oil on a 2005 Ford Explorer. First, find the oil drain underneath the vehicle and remove it. Once you remove it, let the oil drain into an oil pan underneath the car. Let the oil drain completely out, then when it's finished replace the plug. Now, go to the hood of the car and remove the cap from the oil can. Place a funnel inside and then pour your new oil into the can. When finished, replace the cap and start the car. Now go back and check t...