In this how to video, you will learn how to install and replace the glow plug in your RC car. Glow plugs are used to ignite the fuel in the engine. A glow ignition makes the filament in the plug red hot. To check if the glow plug works, place it on the ignition and check if the filament is bright red. This is very easy, as you just need a 4 way wrench. Slide it in the engine and take the glow plug out by spinning the wrench counter clockwise. Once this is done, place the new glow plug in and ...
In this video, we learn how to shoot a soccer ball the proper way. First, set the ball up to your dominant foot. Then, place the non-kicking foot around 6 inches to the right or left of the ball. Now you will aim to make solid contact with the laces of the shoe. Next, try and make solid contact with the laces of your shoe. Doing this will make sure the shot is powerful and not spinning. Also, aim to keep your foot as vertical as possible when making contact, which will send the shot low and a...
In this how-to video, you will learn how to put back a 2 speed central gearbox in your RC vehicle. Take the time to clean your car. Remember that the shorter dog bone goes to the rear and the longer one goes to the front. Slide the dog bone in and make sure that it spins the wheels. Now, raise the dog bones and slide them into the drive cuffs of the central transmission. Once this is done, check by moving the tires to see if the gears are moving. Make sure the box fits into the place provided...
To throw a clay pottery fruit bowl, place a lump of clay on the potter's wheel and wet it with water. Use the foot pedals to spin the wheel while shaping the clay with your hands. Draw the clay up and then use your thumbs to create an indentation in the center of the clay. Apply slight pressure and the clay should assume a bowl form. Use water as necessary to create the right clay consistency. Draw the clay up to make the bowl walls thin. While shaping the bowl walls with one hand, create a r...
In this video tutorial, viewers learn how to do a hard flip on a skateboard. Users should learn how to do a kick flip and front-side flip. Begin the back foot on the edge of the tail and the front foot on the center of the board. Pop the tail down and flick thee front foot outwards. Slightly rotate your shoulder to spin the board without rotating the body. Catch the board in mid-air with the front foot and land on the board with the back foot. This video will benefit those viewers who enjoy s...
To begin with, you may want to learn how to kick flip before you try to do a casper flip as that is half of the trick. Try practicing it at a low speed as there is a lot of movement with your feet and this will help you keep control of the board. Now set your front foot on the two bolts in the front of your board and have your back foot square. Pop the board up like a normal kick flip, sliding your foot underneath the board as you flip it and when it is flipped over, spin the board back aroun...
In this video tutorial, viewers learn how to do a hand plant on a skateboard. Users will first need to be able to do low kick turns, using one hand on the ground. After comfortable doing the low kick turns, try grabbing the board and lifting it up as you turn. Practice this at least 5000 times. Once you are ready, try lifting your board and spinning it in a 180 turn. Try it on a small ramp first and as you gradually get better, use larger ramps. The faster you go, the easier it is to put your...
This is a great instructional video on how to set up a fishing pole for bass fishing. If you want to set up a fishing pole for bass fishing, you have to use a 6 1/2-foot, medium-action spinning rod with a medium-sized reel. You can discover why it's important not to overpower a bass fishing setup with help from a commercial fisherman in this video on fishing equipment. First you need to insert the thread into the spool and grab it with your little finger. You have to pull it out now. Tie the ...
GiantsMan5 demonstrates how to throw a basic curve-ball. First, don't listen to people who say there's only one way to throw a pitch. Position your fingers on the four seams of the baseball. Unlike a fastball, which you throw straight, to throw a curve-ball, move your wrist in and let the baseball drop during the pitch. By throwing an effective curve-ball, you give it top spin so it drops after you release the ball. Use different grips to control the speed of the curve-ball. You can also thro...
Get that board spinning! Let the guys show you how to nail the perfect kick flip, or as it was formerly know, a magic flip. The kick flip's principles are simple and can be done by anyone who follows this video correctly. It isn't hard to follow this video as each step is broken down and played in slow motion with a detailed and concise explanation. While also showing off their own moves, we see how to avoid common errors and problems we may encounter as we embark on nailing the perfect kick ...
In this video tutorial, viewers learn how to perform a kick flip on a skateboard. is a skateboarding trick where the skateboarder drags his front foot at an angle up the nose of the skateboard in order to make it flip 360 degrees along the board's axis. Begin with back foot in an ollie position, while front foot is angled. Start by sliding the foot onto the toe kick outwards behind you. After sliding, you will need to jump and keep feet away from the board's spin. As you see the grip tape com...
Anyone can learn how to draw an owl on their computer with this easy to follow guide from [www.DrawingNow.com Drawing Now] with just a basic paint program. This video tutorial shows you how to start with just the basic skeleton of the bird, and slowly add layers to it to get the finished product. Watch as the artist adds various colors for the wings, face, body and even a colorful branch for it to perch on. Get creative with this starting point and add your own flair and unique spin on this f...
Learn how to make sparks with steel wool wire and a battery in simple steps. You will need thin steel wool, string wire, a battery with two terminals on top and scissors . First measure a meter of string wire and cut it out using the scissors. Now wrap the string wire around the steel wool exactly in the middle. Rub the battery terminals on the wool to check whether it sparks. Now get outside in a safe place and ignite the steel wool by rubbing the battery. Spin the steel wool by holding the ...
This quick video produced by Toyota USA is a guide to using the Multi Terrain Selector in the 2010 4Runner. The multi terrain select control is designed for off road use. It features for driver selected modes to regulate wheel spin for off road situations. To use the multi-terrain select control, first the vehicle must be stopped with the transmission in neutral. Next, press the On/Off button to turn the selector On, then rotate the mode switch to one of the four available modes. Using this s...
Nighthawkinlight teaches you how to make firework hemispheres. You start with a softball that will be the basis for the strips of paper you construct the hemispheres from. You take craft paper about an inch wide and soak them in a thin wheat paste. You start applying them on the softball in a pattern that doesn't create a lot of layers on top of each other. You need to spin and squeeze the shell to let all the air out. After you've added two layers of paper, clean off the excess wheat paste w...
This video shows how to collar a cylinder. The collar of a cylinder is a plate or ring used under the head of the cylinder for a lock. Put the clay on the spinner. Mold the clay while spinning the spinner. Mold it first to the shape you want. Tighten the neck of the vase that you are molding. By tightening the neck of the vase, you are now shaping the collar of the vase. Shape it to the size and design you want. Enjoy making your own vase with the color you want.
Jfkvideos teaches you how to perform an elite turn combination. This is a combination of a pirouette, coupe turns, a variation of the pirouette and a rotation in reverse. The combination involves a lot of moves and can be done with a lot of practice. Always make sure you're wearing the right outfit for this, as lots of mobility is necessary. The elite turn combination ends with a fall to the ground, so make sure you don't get too dizzy after all the spinning. Watch this video to learn how to ...
Simon Leach teaches you how to do ceramic trimming and sealing. You wet the top of the pot and place it on the wheel. You push down on the bottom, sealed side, when the wheel is spinning. You use the trim tool to cut into the base side. You do this at an angle and make sure you hold the trim tool like a stake knife, not like a pencil. You empty out the leg until you are pleased with it. You round off any sharp corners and you have to put the last piece, the seal. On the bottom you take a piec...
You will need some vodka and orange juice. Take your shaker and fill with ice. Add the orange juice to the ice. Set aside to chill. Next pour off the right amount of vodka you will need. Mix a teaspoon each of green and red food coloring. Add it to the vodka and stir. This should make your vodka appear black. Pour some sugar on a plate and take your martini glass, place it upside down in the sugar, and spin it so the rim of the glass is covered. Put some ice in the glass and fill half the gla...
This video is about becoming a "total driver" in golf.
In this video you will learn how to do a Flair bartend: vertical toss grab reverse grip. Start this trick with an over hand grip, then reverse grip right hand. Reverse grip and pour. Make sure you are holding your bottle security. Your holding the bottle and spinning with the other hand. You might have to practice the end pour so you don't spill as you bring the bottle back up. This video does the sequence many time so you can get the hand work done correctly.
In this video, we learn from Food Network mixologist Miguel Aranda how to put a delicious spin on two classic juice drinks. Not quite as simple as Apple Cider Lemonade sounds, Miguel takes us through each ingredient (the expected, the cider and lemonade, but also lots of nice touches, like star fruit for an extra zing, and fresh ginger and tea to round out the flavor). Miguel takes us through the thought process, and explains to us the intricate taste. This video will have you all set for you...
Ah! The smoky eye, one of the most popular styles of eye makeup today. But what about adding that extra touch? With our hostess, in this quick video, we learn to add a plum accent to your basic smoky eye. Along with recommendations on exact brands we may use, we are given a step by step look at the exact application. Starting with a base of pale purple, and blending toward grays, a metallic effect is achieved, leading out to the leading edge of the eye, then, with darker tint. Blacks, and dar...
Snowflakes are wonderful things. Recreating the patterns in paper is very enjoyable.
If you're hungry for some vegetables and want to add a tasty spin, then this broccoli recipe could be right up your alley. A broccoli in cheese sauce recipe is an easy dish to create in your own kitchen. In this online video cooking lesson, Chef Todd Mohr demonstrates how to make a quick and easy broccoli in cheese sauce by first creating a butter and flour roux. Milk is added to the roux to make bechamel sauce. Then, you can add any type of cheese you'd like to create your own broccoli in ch...
Know how to do the pindrop? Well, how about the advanced pindrop? Team ExClu$!v3, an advanced team of jerk dancers, take us through a couple advanced pindrop (sometimes known as the "baydrip") moves including the "Hell Drop" and "The Stickpin" ...meaning you stick your leg and hold it at all times, coming up spinning? Confused? Watch the video. Team Exclu$sive makes is all look so easy.
Trampolines are just for backyard fun… there's skill involved, so let Trampoline Tricks 1080 show you some cool trampoline tricks.
Casting a fishing rod can be tricky, and we've all had knots in our spools. This fishing clip will show you how to adjust your reel so that you never have knots again. Take action: set the spool tension knob and set the reel breaks. The reel should stop when bait hits water. Ron, the instructor in this how-to video from Live Strong, is a professional bass fisher and has qualified for the Bass Master Classic and has won two B.A.S.S. Western Divisionals. He has also recorded multiple top ten fi...
Active Expert Gale Bernhardt provides helpful tips for cadence and gearing while climbing in this instructional climbing video. When riding uphill, it's very common for riders to want to use a big gear and mash on those gears. That style of riding is hard on your knees and metabolic system. What you want to do is have more of a spinning cadence when you go up the hill. Don't be afraid to shift.
Take a look at this instructional video and learn how to perform the impressive looking butterfly twist. You may have seen this move performed in various martial arts movies. This acrobatic technique is simple to perform. The first dip is crucial. After you dip, your head will be facing the other direction and as you jump, you essentially hug yourself and spin in the air before landing on your feet. Sounds complex? Check this tutorial out.
This segment is from the old "Basics" video by Transworld RIDEbmx. From rolling moves to spinning moves, Chad DeGroot and Day Smith teach you some of the building blocks of flatland riding. If you are so used to riding on ramps and hills, you might have forgotten how important it is to learn flatland BMX riding. Well, Chad DeGroot and Day Smith teach you all about flatland BMXing. Just see how to ride on flatland with your BMX bicycle, learning bike tricks and everything else.
Professional BMX rider Ben Snowden teaches you how to do a 540 on a box jump landing, quarter pipe, and vert ramp. He also throws down some extra moves at the end of the video tutorial in a bonus solo riding session. So, if you want to be an awesome BMX bicycle king, just learn how to do a 540 trick on a BMX bicycle. Ben Snowden will tell you all about it, but he recommends you already know how to do a 180 or 360 spin on your bike.
Ever wondered how a tornado works? Well, wonder no longer and watch this video tutorial for teachers and students alike. You will see how to create tornado demonstrations for use in the classroom or for fun.
The Tesla CD Turbine is a little homemade turbine made from CD's, CD spindle, supermagnets, and glue. It runs on faucet water pressure.
The Tesla CD Turbine (the little turbine made from recycled CD's and magnets) is used as a magnetic test bed for this SinkScience experiment. Here, six 3/16 inch diameter neodymium ball magnets are placed in a plastic bowl above the CD Turbine.
MrfixitRick demonstrates a magnetically-coupled Salad Spinner run by the Tesla CD Turbine on faucet water pressure.
This series of lampworking videos shows how to make a spun glass chess set. Part 1 of 6 - How to Make a glass chess set.
As promised for nearly the whole school year now, I have finally explained how to do two simple pen tricks. There are many such videos on YouTube and elsewhere, but many (students) have requested me to explain it too, so here it is.
Ken Bohannon demonstrates tying the Dahlberg Diver, a deerhair fly - for fly fishing. Part 1 - Preparation, adding the tail and the hair collar. Part 2 - Spinning and Stacking Hair. Part 3 - Shaping the hair. Part 4 - Final Touches. Ken applies the final touches including the eyes to his fly.
Your vehicle's power steering pump is integral to your car functioning at all. That's because the power steering pump is what provides the hydraulic power for steering. Without it, your car would pretty much go nowhere. Inside the pump, retractable vanes spin, pulling hydraulic fluid in with low pressure and spitting it out at high pressure. Every pump has a pressure relief valve to make sure the pressure is never too high, but still your steering pump may wear out over time.
