Teflon Tape Search Results

How To: Make a complete duct tape wallet with an ID holder

You know those little clear pockets in your wallet that perfectly fit your driving license or school ID card? Didn't think you could get them in a homemade duct tape wallet, did you? Well, think again! In this clip, you will learn how to make a complex wallet out of tape including credit card slots and a see through ID holder. Follow along and get started.

How To: Properly tape an ankle

In this how-to video, you will learn how to properly tape an ankle. This is important if you have trouble with your ankle turning. First, spray some pre-tape on the foot. Put on some Pro Wrap so that the tape does not tear the hair on your legs. Put some heel and lace pads on so that the friction of putting on a shoe does not cause blistering. Put in about two to three anchors. Do not use zinc oxide tape around the muscle, so place it under the muscle. Now, start the tape on the inside of the...

How To: Tape and decorate a hula hoop

Add a little bit of flair to your hula hoop. Ribbons and tape can add some color and design to an otherwise plain hoop. However, it's important to be careful of certain techniques when decorating as to not disturb the aerodynamics of the hula hoop. Watch this video tutorial and learn how to tape and decorate a hula hoop.

How To: Make a book without glue

In this tutorial, we learn how to make a book without glue. First, you will need two thick pieces of cardboard paper, the paper for the book, scissors, duct tape, tape, and a pen. First, punch holes in all the papers and cardboard. Now, assemble the book and tape the duct tape around the holes in the book. Roll the tape around and tie it together, do this to all the holes. Now, place the tape around the edge of the book and tape the edge together like the binding of a normal book. Now, write ...

How To: Perform a simple ankle tape job

Sports medicine skills can be tricky and confusing. This video shows you how to tape an ankle correctly to immobilize the joint and keep it protected. You'll learn rules about where to tape and where not to tape. Tension is important and this instructor covers where to add tension and where not to. Using a few simple techniques, you'll learn how to wrap safely from below the calf and down the foot. Learn a few taping techniques like the figure eight, anchoring, stirrups and basket weaving to ...

How To: Build your own stomp rocket out of household materials

In this video, we learn how to build your own stomp rocket out of household materials. Materials you will need are: plastic bottles, bicycle inner tube, 2 feet PVC pipe, duct tape, masking tape, and file folders or card stock. Now, take your PVC pipe and roll paper around it and tape it. Then, remove the paper from the pipe and tape it more so it's completely closed. Then, make your nose cone for the rocket. Place this and the wings onto the rocket in your choice of colors. Then, make the lau...

How To: Wrap a gift

In this video, we learn how to wrap a gift. You will need: scissors, your gift, tape, and wrapping paper. First, place your gift down on the rolled out wrapping paper upside down. Measure out the paper so you have enough, then cut the paper from the roll. Next, you will fold the edges of the paper down, then center the gift on the paper. Bring the sides of the wrapping paper into the middle, then tape it. If you have too much paper on the edges, cut it carefully with the scissors. Now, push d...

How To: Measure for a custom tailored dress shirt

In this tutorial, we learn how to measure for a custom tailored dress shirt. All you need is a flexible measuring tape. First, take your tape measure, and wrap it around the neck, then add 1/4". To measure the chest, wrap the tape measure under the armpit and over the blades of the shoulders. You will go across the nipple line with this measurement. When you do the waist measurement, you want to go around the widest part of the midsection. Take your tape measure and don't squeeze around the w...

How To: Make accent spikes for your hair bows

In this how to video, you will learn how to make the finishing edges on pieces of ribbons. The hardest part is getting the spikes even on both sides. Fold up the ribbon so the two ends meet. If the spike is just a single angle, tape the edges at the top. If the spike has a center to it, bring the ends together and fold it in half. Take a piece of tape and place it around the ribbon ends. This will hold them in place for when you make the cut. If you want to make an angle cut, take your scisso...

How To: Make duct tape roses

Sick of your flowers dying after just a few short days? Want to give your sweetie a bouquet, but can't afford the high florist prices? Make flowers out of duct tape! That's right, duct tape. This instructional video shows you step by step how to go from household material to decorative flowers. With some colored duct tape, a straw, and a pair of scissors you to can make custom flowers out of something you can pick up at the hardware store.

How To: Make a photo cube

In this tutorial, we learn how to make a photo cube. This project can be done in a couple of hours and only costs a couple of dollars! To start, you will first get an exact measurement of the width of your wood. After marking these, you will cut the wood using a band saw. After the eight blocks are finished, line them up in a cube and use clear packing tape to secure them together. Use a sharp blade to trip the tape. You can then open up the cube to show six different sides and tape your phot...

How To: Build your own Japanese katana out of foam

If you're looking to play a samurai or other Japanese inspired character at your next boffer larp, this tutorial is for you. You're shown how to build a foam katana using duct tape, a razor blade, measuring tape, cloth athletic tape, DAP contact cement, liquid craft latex, fabric to cover your blade, rope, fiberglass core, and of course, foam!

How To: Attach guzheng nails onto your fingers

In this video, we learn how to attach guzheng nails onto your fingers. You will need: set of 4 guzhen nails and surgical tape to do this. First, place the nail on the underside of your finger with the tip protruding. Next, take a strip of surgical take and stick it onto the nail at one end, then roll over your finger. The tape should go over your finger 2.5 times. Make sure the tape isn't too loose or tight, and that it's just right around the finger. Repeat this process on all of the nails, ...

How To: Wrap a present

In this tutorial, we learn how to wrap a present. First, lay the wrapping paper on a flat surface and cut it so it's wide enough to fit the gift. After this, place the present in the middle of the paper and fold one side out to the edge, then make a crease and tape it. Now, take the other side and fold it up the side, then make a crease and tape that. After this, you will bring the sides up and fold the creases on the bottom and on the top. Next, make creases on the side of the box and then t...

How To: Make a duct tape wallet with credit card holders

Check out this video for advice on how to build a brand new wallet out of duct tape. These aren't just ordinary wallets, either, they have slots for credit cards and everything! These are complete billfolds and can be made into plenty of different style depending on your preference. So, follow along and once you get the hang of it, why not experiment and create your own design?

How To: Make a Christmas tree from sheets of rolled newspaper

This video demonstrates how to make a christmas tree out of newspaper. The author suggests that you start with 3 full sheets of newspaper and have scissors and scotch tape ready to use. Begin the tree making process by rolling the newspaper tightly and then using the scissors to create multiple cuts on one end of the roll. After doing so the newspaper roll should achieve a frayed look on one end. Pull on the frayed side to elongate the other newspaper that was rolled inside previously and the...

How To: Make a duct tape coin purse

Is there anything duct tape can't do? You can use it to temporarily repair leaking pipes, patch up broken furniture, build seaworthy boats (as proven on "Mythbusters") and so much more. But did you know you can also use it to make cheap fashion accessories? Indeed you can, and in this video tutorial a young lady shows you how to make a coin purse out of duct tape.

How To: Make a newspaper tree

The Professor of Silliness returns with some paper. Watch this instructional video to make a tall tree out of newspaper. You need an old newspaper, masking tape, and scissors. Simply lay out the newspaper pages from end to end and tape them together. Then roll it up at a diagonal, starting from one corner, and pack i it into a compact tube. Use tape to keep the tub intact Use the scissors to cut vertical lines half way down the newspaper tube. Pull out the inner most layer and turn your recyc...

How To: Build a sonic fabric reader

Sonic fabric is a textile woven from 50% cassette tape and 50% polyester thread. This video illustrates how to build a "reader" that will enable the user to listen to the sound embedded in the fabric. This allows you to play non-traditional music from clothing that's made of cassette tapes.

How To: Read a tape measure like a professional

In this tutorial, we learn how to read a tape measure like a professional. Rulers are awkward and you can't measure something over 13 inches with them. A retractable tape measure will measure as long as you would like and it has different markings on it. It has an inch, half inch, and goes on and on. The smallest is 3 32nd's of an inch. As you become more familiar with measuring the tape measure, you will take more accurate measurements for the projects you're working on. When finished learni...

How To: Make a fashionable hat from duct tape

In this tutorial, we learn how to make a Duct tape hat. First, grab a hat that you want to duplicate and measure it out with a piece of paper. Then use this piece of paper as reference to how you will cut your pieces of duct tape. Now, cut the duct tape and stick them together to create the top of the hat. After this, you will connect the other areas of the hat together and make the bill of the hat. This will need to be thicker than the other areas and you will also have to cut it into a curv...

How To: Make a duct tape wallet with a change pocket

In this video, we learn how to make a duct tape wallet with a change pocket. First, grab your favorite color of duct tape and then place some down on a flat surface with the sticky side up. Overlap these until you have the desire size you want, then fold the edges over. After this, apply the sticky side down to this and you will have a nice little wallet that is made between them connecting to each other. Make the change pocket by doing the same process, just use a smaller piece and connect w...

How To: Accurately read a tape measurement

In this tutorial, we learn how to accurately read a tape measurement. First, roll out the tape measure, then find the inch marks. These will be in red. From here, you will find the half inch marks between each of the red inches. Half of the half inches will be right in the middle of that, and exactly half of the half! In between this, you will find 3/4 of an inch and 1/8 of an inch. Make sure you have a good view of the lines on the tape measure so you can identify these correctly. The last m...

How To: Decorate with duct tape Kanji characters

This video will show how to decorate duct tape creations with Japanese Kanji characters, which are Chinese-based characters. After creating your duct tape stencil which will serve as a backing, you should go online and find a Kanji character which you would like to copy, print it out on paper, and cut it out with scissors. Place the characters on your duct tape and trace around the character, making a stencil of the character you would like. Finally, you need an X-acto knife, which you will u...